/*!
 * @file        readme.txt
 *
 * @brief       This file is routine instruction
 *
 * @version     V1.0.0
 *
 * @date        2026-01-31
 *
 * @attention
 *
 *  Copyright (C) 2026 Geehy Semiconductor
 *
 *  You may not use this file except in compliance with the
 *  GEEHY COPYRIGHT NOTICE (GEEHY SOFTWARE PACKAGE LICENSE).
 *
 *  The program is only for reference, which is distributed in the hope
 *  that it will be useful and instructional for customers to develop
 *  their software. Unless required by applicable law or agreed to in
 *  writing, the program is distributed on an "AS IS" BASIS, WITHOUT
 *  ANY WARRANTY OR CONDITIONS OF ANY KIND, either express or implied.
 *  See the GEEHY SOFTWARE PACKAGE LICENSE for the governing permissions
 *  and limitations under the License.
 */

&par Example Description

This example shows how to use the alarm of RTC module. Press key1 or
key2 to create an alarm event, when the alarm clock in active state,
LED_GREEN will keep on, when the alarm clock has arrived, LED_GREEN turn off.
LPUART1 will export information.

&par Hardware Description

KEY1: PC12
KEY2: PC13
LPUART1 is configured as follows:
    - TX:PC7, RX:PC6
    - BaudRate = 115200 baud
    - Word Length = 8 Bits
    - One Stop Bit
    - No parity
    - Hardware flow control disabled (RTS and CTS signals)
    - Transmit enabled

&par Directory contents

&par IDE environment

  - MDK-ARM V5.36.0.0
  - EWARM V8.50.5.26295
  - Eclipse V2022-06(4.24.0)

&par Hardware and Software environment

  - This example runs on APM32F445 EVAL Devices.
